USD $50.00
Replaces the factory fan belt sensor pulley with an anodized aluminum version.
Includes all hardware as well as a high quality SKF bearing.
Available in anodized red or black. Can be mounted in two orientations based on aesthetic preferences.
Note: Modifications are required to the factory belt sensor housing in order to install. A 6mm hole must be drilled through the body to remove the factory bearing, with a 90 degree countersink on the back side for screw clearance. A countersink bit can be found here
Installation instructions can be downloaded here
The bearings on the factory belt sensor are non-serviceable. They are known to seize and either destroy the belt sensor, or worse yet the belt itself.
This upgraded pulley is made from anodized Aluminum and replaces the factory plastic pulley. The bearing is fully serviceable should it ever wear out. We use a SKF sealed bearing that is rated to 80,000 RPM as pulley can spin upwards of 30,000 RPM at redline.
Bearing, stainless steel bolt and locknut are included.
| Weight | .5 lbs |
|---|---|
| Color | Black, Red |
Reviews
There are no reviews yet.